suny76 ha detto:
a parte che parlano di 805, non c'è alcun comunicato ufficale Onkyo e nello stesso tread che avevo già seguito da tempo c'è la stessa incertezza che aleggia tra il mio 605 e le mie wharfedale!
Suny, ecco quello che ho scritto al Customer Service di Onkyo
"...Dear Onkyo,
I have just purchased my TX SR605, and I was wondering if it is possible
to BI AMPI the receiver with my Front speakers Wharfedale Diamond 9.5
(6ohm). Looking at the Manual, it refers only to 8ohm speakers, is that
correct?.."
ecco cosa mi hanno risposto...
"...Dear Camillo
thank you very much for your message and your interest in ONKYO products.
You have reached the support/help desk for ONKYO Europe.
Bi-Amping.
If you use bi- amping with 8 or 6 ohm speakers , you don't have to change
the impedance mode.
If using 4 ohm loudspeakers , you must switch the Receiver to 4 ohm
impedance.
"Bi-amping or Bi-wiring" is possible with 4 ohm speakers , unfortunately
the instruction manual is not quite clear at this point.
Please set the same impedance at the receiver like the speaker impedance
is.
"If the speaker impedance is critical , that means the impedance is strong
under 4 ohm , it's possible that give problems, in this case it's not
possible to use this loudspeakers."
Important:
"BTL" ( bridge-mode) is only possible with 8 ohm loudspeakers !!!
If you need more detail information please get in contact with your local
ONKYO dealer or ONKYO distributor !
For further information please contact your local ONKYO distributor (look
at:
www.intl.onkyo.com/support/local_support/index.html ):
Io quindi credo che si può tranquillamente fare il BiAmp...tra il 605 e le Wharf...se vuoi in 2 settimane quando monterò insieme il tutto..ti faccio sapere....ma mi sembra abbastanza chiaro, che ne pensi?
