matrix2 ha detto:
(Attimi di panico quando si è spento ) tutto ok non ha nemmeno perso le impostazioni sarà durato 2 minuti scarsi
Che si sia spento è del tutto normale,è anche indicato nella procedura ufficiale,ma se uno non lo sa,il vuoto nello stomaco viene eccome !
Firmware update procedure
Do not turn off the TV set or disconnect it from the power supply during the update process. Doing so may damage your TV set and make it unusable, and would require a repair.
Do not press any other button, except as instructed, until the update is complete. Doing so may damage your TV set and make it unusable, and would require a repair.
The firmware update process may take up to 5 minutes. First read the whole procedure before starting to update the firmware of your TV set.
Turn on the TV set
Insert your USB device containing 'sony_dtv0FA00A00A0A0_00020100' into the USB slot located at the side of the TV set.
A series of different messages will appear on the TV set. Please follow the on screen instructions.
The POWER indicator will be green for 30 seconds, followed by the PIC OFF/TIMER indicator slowly flashing amber, and the STANDBY indicator is red.
After several minutes, the TV will turn off and then turn back on to complete the update.
CAUTION: During the firmware installation process, do not remove the USB device, or switch off the TV set or remove the power.
When the firmware update is completed, a message is displayed on the TV set.
The software update is completed.
or
Newer version not detected.
Safely remove your USB device from the USB slot
To check the TV firmware version:
Power on the TV set and press the HOME button on the Remote Commander to display the Home Menu (XMB™).
Navigate to the 'Product Support' category and press OK to select it.
Navigate to 'System Information' and select it.
Confirm the version number which is shown on the column of 'Software Version'
If the version number is PKG1.104EUL-0103, your TV set has been correctly updated.