Translate with GOOGLE
FIRMWARE 1512 (Last firmware for 40-46-52 W4500)
http://www.megaupload.com/?d=SGAKZX16
MEMORY STICK formater
http://www.sonydigital-link.com/rme/downloads/downloads.aspx?m=&f=MSFRM
01 - Open the folder named W4500.
02 - Copy the entire folder called
polo_proto1 in MEMORY STICK in the root.
-------------------------------------------------- -------------------------------------------------- ----------
01 - Before the UPDATE, switch on your TV, put on a DIGITAL channel (push DIGITAL button near ANALOG button on the remote), then turn off the power button located on TV. It should not be in standby before proceeding.
02 - Disconnect all cables from the TV (HDMI, SCART, YUV, RCA). Only the antenna cable should remain connected.
03 - Disconnect power.
04 - Put the Memory Stick slot in the "SERVICE ONLY" button on the left side.
05 - Reconnect the power supply.
06 - Press the POWER button on the TV.
07 - Wait about 10 to 15 minutes, the screen is black, so do not worry, the LEDs Red, Green and Orange will begin to flash, fade, flash, etc. ...
At 2 minutes, a message "START UPDATE" will appear on the screen for a few seconds, then the screen will be black again.
During the SHIFT, TV reboot 1 or 2 times, it's normal.
08 - Once the setup menu (language selection) appears and only the green POWER light is on, it's over.
VERY IMPORTANT, do nothing until the Memory Stick is still in TV. Do not configure your TV yet. Just hit the power button on the TV.
09 -
Disconnect power cable. It is very IMPORTANT.
10 - Remove the Memory Stick.
11 - Reconnect the power supply.
12 - Turn on your TV, the setup menu will reappear, this time you can make your adjustments. If the setup menu does not reappear, make a mandatory RESET TOTAL TV which is in the SETUP menu.
