Ad esempio l'ONKYO HTX-22HD riporta questo nel manuale:
"You can connect components with HDMI outputs to the HTX-22HD’s HDMI IN 1 and IN 2
inputs and connect your HDMI TV to the HTX-22HD’s HDMI OUT. You need HDMI cables to
make HDMI connections.
Note:
• By default, the HDMI1 and HDMI2 inputs are assigned to the VCR/DVR and CBL/SAT
input selectors. To change these assignments, see “HDMI Input Setup” on page 37.
■
Video Signals
Digital video signals received by the HDMI IN jacks are output by the HDMI OUT for display
on your TV.
■
Audio Signals
Digital audio signals received by the HDMI IN jacks are output by the speakers connected to the
HTX-22HD. Normally, they are not output by the HDMI OUT.
To listen to audio received by the HDMI IN jacks through your TV’s speakers,
set the Audio TV Out setting to On (see page 68), and set your DVD player’s
HDMI audio output setting to PCM"
e alla citata pagina 68 dice:
"Audio TV Out
This setting determines whether audio
received by an HDMI input is output by the
HDMI OUT. You may want to change this
setting to On if your TV is connected to the
HDMI OUT and you want to listen to audio
from an HDMI component through your TV’s
speakers instead of the HTX-22HD’s speakers.
Normally, this should be set to Off.
Off:
HDMI audio is not output (default).
On:
HDMI audio is output.
Notes:
• If On is selected and the signal can be output
by the TV, the HTX-22HD’s speakers
will output no sound.
• When TV Control is enabled, this setting is
set to Auto.
• With some TVs and input signals, no sound
may be output even if On is selected.
• When the Audio TV Out setting is set to
On, or TV Control is set to Enable and
you’re listening through your TV’s speakers
(see page 25), if you turn up the HTX-
22HD’s volume control, the sound will be
output by the HTX-22HD’s speakers. To
stop the HTX-22HD’s speakers producing
sound, change the settings, change your
TV’s settings, or turn down the HTX-
22HD’s volume."
Siccome mi sembra di capire che per sentire l'audio sul TV dovrei comunque accendere l'amplificatore e settare quel parametro, mi sembra scomodo, dato che non dice (perlomeno non l'ho trovato) che in stan-by è settato di default a passare l'audio al TV.
Per ovviare potrei prendere lo switch che dicevi sopra e ricevere il segnale dalla PS3 rispedendolo in HDMI alla TV e all'amplificatore, così ognuno ha il suo e non bisogna stare asettare nulla. se voglio sentire l'impianto metto muto sulla TV e basta, altrimenti non lo accendo proprio.
?