Roma - Filtro di rete Brick Wall PW2RAUD audiophile

[manuel74]

Roma :
Surge protector Brick Wall PW2RAUD 115 V ideale per apparati con alimentazione USA-Japan (videoproiettori, Amplificatori etc)

Mai usato come nuovo.


lo vendono negli USA a $ 235
http://brickwall.thomasnet.com/item/...aud?&forward=1


vedere la spiegazione delle caratteristiche qui:
http://brickwall.com/prodstds.htm


caratteristiche:
Outlets Available
2 (unswitched)
Load Ratings
15A at 120 volts, single phase, 50-60 Hz; full load regulation 1%.
Endurance Test
1,000 surges of 6,000 volts, 3,000 amperes, SRV <400 volts, no failures, L-N (ground wire protection) mode, U.S. Gov't. Mode 1.
Limiters
Series surge reactor current limiter; cascaded, auto-tracking dual polarity voltage limiters; dual pulse inverters. Parameters optimized for switch-mode power supply protection.
Clamping Voltage Onset
172 volts nominal; 2 volts above peak line voltage (auto-tracking).
EMI/RFI Filter Response
(bi-directional, wave tracking): With 50 ohm Rg load: 3db at 5kHz; 26dB at 100kHz; 38dB at 300kHz.
Let-Through Slew Rate
5,000 volt/µs disturbance reduced to 28v/µs within AC power wave envelope, and less than 10v/µs outside the power wave envelope.
Maximum Applied Surge Pulse Joule Rating
Unlimited rating (due to surge current limiting) (8x20µs).
Maximum Applied Surge Pulse Voltage
6,000 volts (1.2 x 50µs) (Industry Standard rating).
Maximum Applied Surge Pulse Current
>100,000 amperes (unlimited due to current limiting) (8 x 20µs).
Endurance, C62.41-1991 (formerly IEEE 587) Category B3 (C1) pulses
2kv>100,000; 4kv>10,000; 6kv>1,000 (NRTL verified).
Dimensions
3.5" H x 7.85" W x 3.75" D
Weight
5.75 lbs.


Lo vendo a 100 euro.
Messaggi in privato.

bye
Emanuele

[manuel74]

bump
bump